R12DS 12CH 12 Channel Receiver 2.4Ghz For AT10 Transmitter Aircraft Aerial Photography Device | Drone Accessories Kits

R12DS 12CH 12 Channel Receiver 2.4Ghz For AT10 Transmitter Aircraft Aerial Photography Device | Drone Accessories Kits

RadioLink R12DS 12CH 12 Channel Receiver 2.4Ghz For AT10 Transmitter Aircraft Aerial Photography Device
 
Radiolink R12DS, 2.4G 12 channels receiver, DSSS and FHSS spread spectrum working synchronously, compatible with Radiolink transmitters AT9, AT9S, AT10 and AT10II(AT9, AT9S, AT10 and AT10II can upgrade to 12 channels just upgrade by firmware, you can download the firmware from our website:

S-BUS and PWM signal working at the same time.
Two signal working mode:
(1) PWM signal output working mode:red LED indicates PWM signal output, 11 channels Totally.
(2) S-BUS signal output working mode:blue/purple LED indicates S-BUS signal output, 12 channels totally.
 
S-BUS and PWM signal working at the same time. S-BUS signal channel(3 pin of row 11) output 12 channels S-BUS signal, PWM signal channels(3 pin of row 1 to row 10) output CH3 to CH12 PWM signals, but 12 channel in total. How many PWM signal channels you can use depends on how many S-BUS signal channels you have used(e.g: you have use 4 S-BUS signal channels, then you have 8 PWM signal channels to use).

How to match code with transmitter:
1. Put the transmitter and the receiver close to each other within 1 meters.
2. Turn on the transmitter, then power on the R12DS.
3. Connect CH3 of R12DS to ESC.
4. There is a black button on the R12DS, use a thin stick press the button twice in two seconds, receiver light starts blinking, after about blinking 8 times, match code success and receiver signal LED always on!
 
Specification:
1) Channels: 12 channels:output12channels signal, supportS-BUS and PWM signaloutputsynchronously.
2) Working voltage: 4.8-10V
3) Working current: 38-45mA  input voltage: 5V
4) Size: 50*31.5*14.5 MM
5) Weight: 14g