10pcs/lot 3 in 1 Soldering Iron Lighter Outdoor 1300 degree Torch Jet Flame Lighters Welding Burning Heating Pen | Дом и сад

10pcs/lot 3 in 1 Soldering Iron Lighter Outdoor 1300 degree Torch Jet Flame Lighters Welding Burning Heating Pen | Дом и сад

3 in 1 Soldering Iron Lighter Outdoor 1300 degree Torch Jet Flame Lighter Welding Burning Iron Heating Pen

Features:

Note:
Transition: 1cm=10mm=0.39inch
Please allow 1-2cm error due to manual measurement. 
Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!

Use For:
1. Rust-corroded screw kit, laboratory heating, kitchen baking tools, factory equipment maintenance.
2. Welding of automobiles, trucks, aviation repairs, and hydropower engineering repairs.
3. Electrical and motor control box repair welding
4. Circuit board maintenance welding, IC version welding, home field line welding, etc.
5. Tin soldering on the component.                                               
How to fill gas:
1. Fill in the high-quality gas and confirm that the switch is at the OFF position.
2. Introduce the gas tank into the air hole and press down to inflate.
3. About 10 seconds, can complete the filling of gas, wait a few minutes, let the gas stabilize, and then use.
4. When the gas is filled in, and there is a squeaking sound in the tail, press the tip of the pen slightly into the air port to eliminate it.
Ignition:
1. Push the switch to the ON position.
2. Push the flameout ring forward.
3. Use an igniter or lighter to ignite near the joint.
4. Burn after burning for 3 seconds, then return the flameout ring to the original place, until the fire goes out, the iron head will continue to heat.
5. Adjust the size of the flame, to the direction of +, the direction to - is small.
6. This product temperature up to 1300 ℃ (ironing iron temperature 450 ℃ ) should pay attention to safety when using, turn off the switch after use.
7. When using a gas soldering iron, please pay special attention to wait until the flame is completely eliminated. When the object inside the soldering iron turns red, operate again. The flame size should not be large to extend the life of the soldering iron.
8. The length of the flame is about 1.2-1.5 cm